Cambium Networks PTP 450 Series, Руководство по настройке

Страница: 170 / 649

Chapter 1: Configuration Configuring security
Page
1-142
Attribute Meaning
Authentication Key Only if the BHM to which this BHS registers requires an authentication,
specify the key that the BHS will use when authenticating. For alpha
characters in this hex key, use only upper case.
Disable AES 128-bit Refer Table 40 Security attributes –450 Platform Family AP on 1-126 for
parameter details.
Authentication Key
256-bit
Web, Telnet, FTP
Session Timeout
Enter the expiry in seconds for remote management sessions via
HTTP, telnet, or FTP access to the BHS.
IP Access Control
You can permit access to the BHS from any IP address (IP Access
Filtering Disabled) or limit it to access from only one, two, or three
IP addresses that you specify (IP Access Filtering Enabled). If you
select IP Access Filtering Enabled, then you must populate at least
one of the three Allowed Source IP parameters or have no access
permitted from any IP address
Allowed Source IP 1 to
3
If you selected IP Access Filtering Enabled for the IP Access Control
parameter, then you must populate at least one of the three Allowed Source
IP parameters or have no access permitted to the BHS from any IP address.
You may populate as many as all three.
If you selected IP Access Filtering Disabled for the IP Access Control
parameter, then no entries in this parameter are read, and access from all IP
addresses is permitted.
A subnet mask may be defined for each entry to allow for filtering
control based on a range of IP addresses.
Web Access
The Radio supports secured and non-secured web access protocols. Select
suitable web access from drop-down list:
• HTTP Only – provides non-secured web access. The radio to be
accessed via http://<IP of Radio>.
• HTTPS Only – provides a secured web access. The radio to be accessed
via https://<IP of Radio>.
• HTTP and HTTPS – If enabled, the radio can be accessed via both http
and https.