Viper SC+™ IP Router for Licensed Spectrum PN 001-5008-000 Rev. C
| Page 128
Data Key
Enter the data key here and click Set Key. This must match the key set in the WCP server database. The key lengthe
myst be
exactly
16, 24, or 32 characters, corresponding to the data key strength values 128, 192, or 256. Click Set
Key to set the data key.
Logout and Save
— Click to log out and save the new configuration.
Logout and Don’t Save
— Click to log out without saving the new configuration.
The new configuration will be lost after a unit reset.
WCP Settings
Unit ID
Enter a unique identifier to identify this unit. This can be used when a file upload is targeted to this specific unit.
Group ID
Up to four (4) group IDs may be entered. This unit will participate in a file upload targeting
any
of these Group IDs.
IP Settings
Multicast Group
The WCP server uses multicast messages to target all units simultaneously. Therefore, the multicast group address
must match that which is used on the server for a file upload targeting this unit.
Local Port
The IP port number entered here must match that which is used on the server.
Remote IP Address
The destination IP address used when sending WCP messages. (If “auto-response” is enabled, this parameter is not
used.)
Remote Port
The destination port number used when sending WCP messages. (If “auto-response” is enabled, this parameter is
not used.)
Auto Response
When sending a WCP message (UDP), do not use the remote port and remote IP address configured, but rather
send to the IP address and port number of the last WCP message received. When this feature is enabled, drop any
message to transmit until at least one message is received.
Note:
If you change the Multicast Group or Local Port in the IP Setting section in this tab, a reset of the Viper is
required before the setting will take effect, as indicated by the yellow alert symbol (
).
General Settings
Forward WC Traffic to RF network
Enable or disable forwarding traffic for the Wing Commander protocol onto the RF network. The default setting is
Enabled.
Note:
If you change the Forward WC Traffic to RF network Enabled or Disabled, a reset of the Viper is required before
the setting will take effect, as indicated by the yellow alert symbol (
).
