Bryant Evolution Connex Control, Руководство по установке

Страница: 23 / 116

14
captured between the backplate and the system control. Align the trim plate around
the backplate, and snap on the system control.
A170245B
4.5.2. System Control Mounting
S
Turn off all power to equipment.
S
If an existing Evolution Control or other control is being replaced:
d
Remove existing control from wall.
d
Disconnect wires from existing control.
d
Discard or recycle old control.
S
NOTE : Mercury is a hazardous waste, if existing control contains any mercury,
it MUST be disposed of properly. The Evolution Connex Control does not
contain mercury.
S
Select the appropriate Evolution Connex Control mounting configuration. Use
the standard backplate (mounting plate) provided with the wall control, or add
the decorative trim plate in addition to the standard backplate if desired. See
Section 4.5 for more detail.
S
Route wires through large hole in mounting plastic. The hole may be enlarged,
if required, to accommodate existing installations; avoid opening the wire hole
more than necessary. Level backplate against wall (for aesthetic value only; the
Evolution Connex Control need not be level to operate properly) and mark wall