Bryant Evolution Connex Control, Руководство по установке, Страница: 22 / 116

13
4.5. Decorative Trim Plate
Sold separately, a thin decorative trim plate is available to hide any marks/screw
holes left from the previous thermostat. The trim plate is captured between the
backplate and the system control. Align the trim plate around the backplate, and
snap on the system control.
A12213
NOTE : Once the Evolution Connex Control is secured to wall with the backplate
assembly (snapped together), care must be taken not to bend or break the
interlocking tabs when removing.
4.5.1 Mounting
First become familiar with all plastic assembly pieces shown on the following page.
The Evolution Connex Control will snap together with the standard backplate
supplied with the wall control. Attach backplate using only a small hole in the wall
allowing a four wire connection to pass through. Mount the front assembly to the
standard backplate. The figure below shows the optional decorative trim plate
installed with the standard backplate, described in Section 4.5.1. The trim plate is