Brusa NLG664-U0, Техническая информация и пуск в эксплуатацию

Страница: 63 / 64

Technical information
and start-up
Fast Charger NLG6xx
63
The process of pre-charging is as follows:
1. The main contactor HV- (3) closes.
2. The pre-charging contactor (1) closes.
Ensure that the pre-charging contactor (1) as well as the pre-charging resistor R
P
(4) are designed for the
maximum pre-charging current. Please note that the pre-charging contactor (1) must be able to interrupt the
pre-charging current in the case of a fault!
Monitor the pre-charging time and open the pre-charging contactor (1) again if the condition U
1
- U
2
< 10 V is
not fulfilled even after a specified maximum period.
3. The main contactor HV+ (2) closes.
The main contactor (2) may only close if the condition U
1
- U
2
< 10 V is fulfilled.
4. The pre-charging contactor (1) opens.
The HV connection to the device is now established.
10
Operation
INFORMATION

The unit is controlled via CAN, please see Software Manual for more information.
Also refer to chapter 4.2 Scope of the documentation .
11
Warranty and Guarantee
The warranty corresponds to the regulations in our currently valid general terms and conditions see under
www.brusa.biz/en/support/terms-conditions.html .
12
Instructions regarding disposal
A basic requirement for the re-use and recycling of used electronic devices is the correct disposal.
With the implementation of the electric and electronic device regulation (ElektroG), since 24 March 2006,
electronic devices may no longer be disposed of along with ordinary household waste but must be
separately collected and recorded by a specialist services.
Disposal through a specialist service significantly helps to avoid dangers to people and nature. Therefore, in
the case of disposal, we recommend contacting a recognised specialist disposal service.