Brusa NLG664-U0, Техническая информация и пуск в эксплуатацию

Страница: 12 / 64

Technical information
and start-up
Fast Charger NLG6xx
12
3.3.3 Safety instructions for handling and operation
INSTRUCTION
Damage to HV battery:

Make sure that the voltage range of the device complies with the voltage range of the HV battery!

Only use technically suitable and high-quality cables! Should you have any further questions,
please contact BRUSA Elektronik AG under the manufacturer address mentioned in chapter 4.6 .
INSTRUCTION
Damage to the charger:

When connecting the device, always ensure that the mains voltage is within the permissible
range (refer to chapter 6.1 Technical data )!

A high cooling water temperature and/or ambient temperature reduces the life span! Therefore,
ensure that the device is continuously cooled sufficiently!

Do not install the device in direct sunlight and in direct proximity to heat sources!

Even though the device has a high IP protection class, direct contact with water (rain, splashing
water) and dirt should be avoided.

Under no circumstances should you put a low-resistance connection between the HV contacts,
the housing contacts and the LV contacts! This will lead to malfunctions and in time to the
destruction of the device!

Prevent any penetration of fluids into the device (e.g. during assembly work)! Fluid ingress will
lead to a short circuit and subsequently to damage to the device!

In the case of any fluid ingression, do not start the device and immediately contact BRUSA
Elektronik AG.

The tightness of the battery charger can only be guaranteed if all the signal cable to the signal
connectors are packaged and connected to a tight unit. If this is not the case in one of the cables,
it must be separately sealed.