Brusa NLG664-U0, Техническая информация и пуск в эксплуатацию

Страница: 29 / 64

Technical information
and start-up
Fast Charger NLG6xx
29
6.6 Dimensions and installation information
For the installation of the charger, the following must be adhered to:

The charger must be installed at a secure location out of reach of the user of the vehicle. This is to
prevent dangers such as accidental touching of HV components or skin burns on the hot housing.

When selecting the installation location, it must be ensured that the pressure compensation membrane
on the housing and the connectors are situated above the wading depth of the respective vehicle.

Despite its high IP protection class, the charger should be installed at a dry location, safe from
splashing water, dirt and stone chipping.

The tightness of the battery charger can only be guaranteed if all signal wires to the signal
connectors are assembled and connected to a tight unit on both sides. If this is not the case for a
cable or wire, it must be sealed separately.

The mechanical fixture is to be designed in such a way, that the device is installed in a fixed position
and with as little vibrations as possible.

The device must not be operated without a functioning cooling system. Failure to do so will result in permanent
loss of the function of the unit.

Cooling water ducts must have sufficient play and must not come into contact with sharp-edged components.

All cable connections must be secured with strain relief elements near the device (not included in the
scope of delivery).

Cable connections must have sufficient play and must not come into contact with sharp-edged components.

The housing cover should be sufficiently ventilated (no heat accumulation).