Brother GTX-4, Руководство по обслуживанию

Страница: 192 / 500

6-1
6
Disassembly / Replacement / Adjustment
This chapter provides information about the procedures to disassemble, replace, and adjust parts.
DANGER
Wait at least 5 minutes after turning off the power switch and unplugging the power cord from the wall outlet
before opening the right side cover. Contact with high voltage sections may lead to a serious injury.
CAUTION
The maintenance and inspection of the printer should only be carried out by a qualified technician.
For electricity-related maintenance and inspection, please ask the store where you purchased the product or
an electrical engineer.
In the following cases, turn off the power switch and unplug the power cord from the wall outlet. The printer
may operate if the Print button is turned on by mistake, which could result in injury.
・
Inspection, Adjustment, and Repair
・
Replacement of parts such as print head and wiper blade
Wait at least 1 minute after turning off the power switch before opening the front cover. Contact with heat sink
located at the top of the head may lead to a burn injury.
Be careful not to get your fingers caught when closing the front cover, otherwise it may result in injury to your
fingers.
Do not drink liquids such as the ink, maintenance solution, wash liquid, pretreatment, or waste.
They may cause diarrhea or vomiting.
Avoid causing your eyes or skin to make contact with the ink, maintenance solution, wash liquid,
pretreatment or waste. It may cause inflammation. In case of contact with eyes, do not rub but immediately
rinse the eyes with water.
Keep the liquids out of the reach of children.
If required to perform the adjustment with the power switch turned on, please pay enough attention to the
safety.
Ensure there is adequate space left in front of the printer and avoid placing any objects. The platen moves
forward while operating and it can strike/damage anything set in its path of
movement.
Do not handle the platen while printing. If your hand gets caught between the platen or the T-shirt tray and
the covers, it may be injured.
Do not put your hands inside the covers while the printer's power is turned on. Otherwise your hands may
touch against moving parts and this may result in injury.
When replacing parts and installing optional accessories, be sure to use only genuine Brother parts. Brother
will not be held responsible for any accidents or problems resulting from the use of non-genuine parts.