Brooks On-Board 8, Инструкция по установке и обслуживанию

Страница: 31 / 56

Cryo-Torr 8600 Compressor Operation, Installation and Maintenance Guide
©2013 Brooks Automation Inc. Pub. No. 8040564, Rev. AA, 01/15/13 ECO No. 64541 2-5
relays, refer to Figure 2-2 and proceed as follows:
The setpoint relays are two mechanical relays that are incorporated into the
On-Board GLE Cryopump for the User's application. The relays are rated
at 1 amp at 25V AC/DC. The relays have both normally-open and
normally-closed contacts. Connection to the relays are made through the 9-
pin D connector labeled Relays on the connector plate on the On-Board
GLE Cryopump. Refer to
Figure 2-2 for pin identification.
Refer to the appropriate On-Board Module Programming and
Operation Instructions for instructions on programming the setpoint
relays.
1. Determine whether your On-Board equipment requires setpoint
relay contacts to be either in a normally-open or normally-
closed position for your application.
2. Referring to Figure 2-2 , prepare a 9-pin DSub mating connector,
meeting MIL DTL 24308/1-1 and equipment requirements.
3. Upon completion, connect the setpoint relay cable to the RELAYS
connector on the On-Board Module.
4. Program the relays as described in the appropriate On-Board
Module Programming and Operation manual.
Figure 2-2: Setpoint Relays Connector Pin Identification
Normally Open (NO)
Normally Closed (NC)
Common
Common
Normally Closed (NC)
Normally Open (NO)
1 2 3 4 5
6 7 8 9
RELAY 2
RELAY 1
RELAYS
24V, 1 A
RS-232
REMOTE AUX TC
NETWORK