30
31
•
Set CV 49 to 12.
•
Set CV 56 to any value between 0 and 255. Chuff rates are calibrated
to be approximately the values shown in the table below. Adjust CV
56.12 value to be higher or lower than these recommended settings
to decrease or increase the chuff rate.
Approximate Chuffs/
Revolution
Scale Factor
CV 56.12 Value
8
.5
16
4
1
32
2
2
64
1
4
128
Reset all
40
CV’s to Factory Default Values (CV 56.128.255)
Note:
This does not affect Analog settings, except volumes.
•
Set CV 49 to 128.
•
Set CV 50 to 255.
•
Set CV 56 to 113
41
. In Ops mode, you will hear 3 hoots when reset is
completed.
Special ID Programming (CV 56.129)
If you cannot program your ID number in Service Mode and your command
station prevents you from changing your ID in Ops Mode using CV 1, or CV
17 and CV 18, use the following alternative procedures to program your
engine ID’s.
Procedure for Entering Short (Primary) Address in CV 56.129 in Ops
Mode
•
Set CV 49 to 129.
•
Set CV 50 to 1.
•
Set CV 56 to your Short Address (1 or 2 digits). Hear the address
spoken back.
•
If necessary, set CV 29, bit 5 to ‘0’ (or set CV 29 to 6 which is factory
default) to enable your new Primary Address.
Procedure for Entering Long (Extended) Address in CV 56.129 in Ops
