14
15
change the System Volume.
Moving on to Other Program Options or Leaving Programming
•
Flip the direction switch at anytime to the opposite position, and
leave it there. Quantum will first return to and announce the current
Program Option and then automatically advance to on to higher
options.
•
Exit Programming anytime you want by turning the power off and
back on again.
Example 1: Setting Throttle Mode (Program Option # 10)
This will determine whether your locomotive uses Regulated Throttle Control
(RTC) or Standard Throttle Control (STC).
•
Enter Programming after powering up your engine by turning the Bell
on, then off and then on as described above.
•
After the “Enter Programming” followed by “Option One - System
Volume” announcement of the first Program Option, flip the direction
switch and leave it there. You will hear the announcement “Option 1,
2, 3 … etc.”. Stop when you hear “ten” by moving the direction switch
back. You will hear “Throttle Mode”.
•
Use a
Slow
or
Quick
operation of the direction switch to enter this
option. If the throttle mode is at its default value (RTC), you will hear
“Mode equals Regulated;” otherwise, you will hear “Mode equals
Standard.”
•
Use a
Slow
or
Quick
operation of the direction switch to change
the throttle mode. Repeated
Slow
or
Quick
operations will cause
the Throttle Mode to alternate between its two possible values,
“Regulated” and “Standard”.
•
Once you have selected the Throttle Mode you wish to use, turn the
throttle off. When you then power up again, your locomotive will be
using the Throttle Mode you have just selected.
Example 2: Setting V-Start (Program Option # 8)
This will determine the voltage (and throttle position) where your engine will
leave Neutral and move out.
•
Enter Programming after powering up your engine by turning the Bell
