Briggs & Stratton Twin Cylinder L-Head, Руководство по ремонту

Страница: 91 / 171

6
6
4. Remove retainer, return spring, spring washer,
pinion gear, and starter clutch, Fig. 16.
Fig. 16 – Removing Starter Drive
STARTER
CLUTCH
RETAINER
RETURN
SPRING
PINION
GEAR
SPRING
WASHER
Disassemble Starter Motor Drive –
Roll Pin Style
If starter is equipped with a plastic cap, it must be
removed before removing roll pin.
1.
Carefully pry the plastic cap off the retaining cup
using two screwdrivers, Fig. 17.
Fig. 17 – Removing Cap Assembly
2. Place starter drive retainer on support block,
Fig. 18 and drive out roll pin with a 5/32” (4 mm) pin
punch to remove starter drive retainer.
1”
(25.4 mm)
Fig. 18 – Disassemble Starter Drive Roll Pin Style
2”
(50.8 mm)
2-5/16”
(58.7 mm)
3/8”
(9.5 mm)
5”
(127 mm)
1” (25.4 mm)
Inspect Starter Drive – All
The pinion gear should be inspected for damaged teeth. Pinion gear must move freely on helix. The parts may be
washed in a solvent such as Stanisol

or Varsol

.
The starter drive assembly is available from your Briggs & Stratton source of supply if required.
NOTE: Do not oil or grease helix or starter gear. See Fig. 19, Fig. 21 and Fig. 22, for proper location of parts.