The probe is equipped with two network interfaces called management (or eth2) and
data/video (or eth0). It is necessary to configure at least one of these interfaces from
the terminal and then do the rest of the setup from a web browser.
The probe supports both in-band management (i.e. using eth0 for both data/video and
management) and separate management (i.e. using eth2 for management). In any
case make sure that the subnets configured for eth0 and eth2 do not overlap –
otherwise the probe will not work properly. Note that if IP-addresses for eth0 and eth2
are configured so that the subnets overlap, the IP-address of one of the ports will be
automatically set to 1.1.1.1 by the probe.
To configure the management interface, edit values for J, K and L, alternatively use
DHCP (I). NB! Set the gateway interface to eth2 by selecting P.
Make sure
Management
(M) is enabled (set to true) – otherwise management via web
will not be possible.
The speed and duplex mode settings are also available here (N, O).
To configure the data/video interface instead, enter values for A, B, C, D, E and set the
gateway interface (P) to eth0.
5. Saving the parameters and rebooting
When all the listed parameters have been configured, the probe must be rebooted to
let the parameters take effect. This is achieved by selecting “R” and confirming by
selecting “t” for TRUE.
PROBE USERS' MANUAL VERSION 5.0
2014 © BRIDGE Technologies Co AS - Bentsebrugata 20 - N-0476 Oslo, Norway - tel: +47 22 38 51 00
-
www.bridgetech.tv
39