55
7. Using a 6mm hex wrench, remove the 8 screws that secure the Con
-
sole Assembly from the Right and Left Uprights.
Note:
To assist with re-assembly, be sure to note that the curved washers
are used facing the rear of the machine.
8. Fully remove the Console and Handlebar Assembly from the Uprights.
9. Using a 6mm hex wrench, remove the hardware from the Side Handle
-
bars.
Note:
To assist with re-assembly, be sure to note that the curved washers
are used facing downward.
10. Remove the Side Handlebars from the old Console Assembly, and
attach to the new Console Assembly.
11. With the new Console and Handlebar Assembly, connect the cables
and attach it to the Uprights.
Note:
This step may take two people to safely hold the Console and
Handlebar Assembly and connect the Cables. Do not crimp the Cables.
12. Re-install all remaining parts that were removed in reverse order.
13. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Side Handlebars
Owner’s Manual.
