38
/104
A4... with HS5E(V)(L) control system Series 1x and 30
| Transport and storage
Bosch Rexroth AG, RE 92076-01-B/2021-04-22
6 Transport and storage
▶ Always observe the required ambient conditions for transport and storage,
see chapter 6.2 "Storing the axial piston unit" on page 40.
Notes on unpacking can be found in chapter 7.1 "Unpacking" on page 42.
6.1 Transporting the axial piston unit
The following optional means of transport can be applied depending on the weight
and duration of transport:
• Transporting with a lifting device (eye bolt or lifting strap)
Table 9: Dimensions and weights (without through drive) of A4VSO
Size
40
71
125
180
250
355
500
750
1000
Weight
approx.
kg
55
68
100
115
197
220
335
475
620
Width
mm Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height
mm
Depth
mm
Weight may vary by equipment.
6.1.1 Transport with lifting devices
For transporting, the axial piston unit can be connected to a lifting device via an eye
bolt in the drive shaft or in the housing. Alternatively, it can also be transported with
a lifting strap.
Only use the lifting strap if you are unable to achieve the required installation
position with transport using the eye bolts.
The axial piston unit can be transported suspended from an eye bolt screwed into
the drive shaft as long as only outward (pulling) axial forces are applied.
▶ For all female threads, use a stud end from the same system of units and of the
correct size.
▶ To do this, screw an eye bolt completely into the female thread on the drive shaft.
The thread size is indicated in the installation drawing.
▶ Make sure that the eye bolt can bear the total weight of the axial piston unit plus
20%.
You can hoist the axial piston unit with the eye bolt screwed into the drive shaft, as
shown in Fig. 9.
Dimensions and weights
Transporting with eye bolt
in drive shaft