BONFIGLIOLI active cube 201, Руководство по эксплуатации

Страница: 172 / 285

172 Operating Instructions ACU 12/16
16.1.1.5 Error and warning behavior
For monitoring the analog input signal, an operation mode can be selected via parameter
Error/Warning Behavior
453 .
Error/Warning Behavior 453 Function
0 - off The input signal is not monitored.
1 - Warning < 1V/2 mA
If the input signal is lower than 1 V or 2 mA, a warning message
is issued.
2 - Shut Down < 1V/2 mA
If the input signal is lower than 1 V or 2 mA, a warning message
is issued; the drive is decelerated according to stopping behavior
2.
3 -
Error switch-off
< 1V/2 mA
If the input signal is lower than 1 V or 2 mA, a warning and
error signal is issued and the drive coasts to a standstill
(stopping behavior 0).
Monitoring of the analog input signal is active regardless of the release of the frequency inverter
according to the operation mode selected.
Operation Mode 2 2 defines the shut-down and stopping of the drive, regardless of the setting of
parameter Operation Mode
630 for the stopping behavior. The drive is stopped according to
stopping behavior 2. If the set holding time has expired, an error message is issued. The drive can
be started again by switching the start signal on and off.
Operation Mode 3 defines the free coasting of the drive, regardless of the setting of parameter
Operation Mode
630 for the stopping behavior.
WARNING
The monitoring of the analog input signal via the parameter
Error/Warning Behavior
453 demands the examination of parameter
Point X1
454 .
Example:
Error/Warning Behavior
453 = “2 - Shutdown < 1V/2mA” or “3 - Error-Switch-Off <
1V/2mA”. In the default settings of parameter
Point X1
454 shutting down or fault switch-off are
effected at an output frequency ≠ 0Hz. If shutting down or fault switch-off are to be effected at an
output frequency of 0 Hz, the Point X1 must be adjusted (e.g. X1=10% /1 V).
50 Hz
9,8 V 0,2 V
Y
X
0 Hz
(X1=2% / Y1=0%)
1 V