BONFIGLIOLI active cube 201, Руководство по эксплуатации

Страница: 253 / 285

12/16 Operating Instructions ACU 253
20.1.1 STO Status
Parameter
STO Status
277 can be used for extended diagnosis of the two inputs STOA and STOB.
The statuses of the inputs are shown in bit-encoded form.
Bit Value Meaning
0 1 STOA input missing.
1 2 STOB input missing.
2 4 Switch off STOA input.
3 8 Switch off STOB input.
4 16 Timeout STOA.
5 32 Timeout STOB.
6 64 Diagnosis error.
7 128 FI error (fault).
With correct wiring and correct function, only the 2 states “0” (= STO enabled) and “3” (= STO
disabled) are typically shown (decimal representation) in parameter
STO Status
277 .
The signal states at digital inputs STOA and STOB can be linked to functions of the frequency
inverter.
292 - STOA Signal state at digital input STOA
284 - STOA inverted Inverted signal state at digital input STOA
293 - STOB Signal state at digital input STOB
285 - STOB inverted Inverted signal state at digital input STOB
Refer to Application manual "Safe Torque Off STO".
20.2 Actual values of machine
The frequency inverter controls the behavior of the machine in the various operating points. As a
function of the configuration selected and the expansion cards installed, control variables and further
actual value parameters of the machine can be displayed.
Actual values of machine
No. Description Function
210 Stator frequency The output voltage (motor voltage) of the frequency inverter.
211 R.m.s Current
Calculated effective output current (motor current) of the frequency
inverter.
212 Output Voltage
Calculated effective value of linked output voltage (motor voltage) of
frequency inverter.
213 Active Power
Active power calculated from the voltage, the current and the control
variables.
214 Active Current
Active current calculated from the rated motor parameters, the
control variables and the current.
215 Isd
Current component of the field-oriented control forming the
magnetic flux.
216 Isq Torque-forming current component of field-oriented control.
217 Encoder 1 Frequency
Calculated from the data on speed sensor 1, the No. of Pole Pairs
373 and the speed sensor signal
218 Encoder 1 Speed Calculation from Encoder 1 Frequency
221 Slip Frequency
Difference from the synchronous frequency calculated from the rated
motor parameters, the control variables and the current.
224 Torque
Torque at the current output frequency calculated from the voltage,
the current and the control variables.
225 Rotor Flux Current magnetic flux relative to the rated motor parameters.