19
8.2 Cutter Assembly
The optional BOCA cutter system is a fully integrated cutter knife mechanism powered by a stepper
motor. The cutter requires no adjustments and is rated for approximately 750,000 cuts. Please be
aware of the following:
Wait five seconds before feeding ticket stock into the printer after power up. During this time the
cutter knife will move up and down. If ticket stock is fed into the printer before five seconds, a ticket
jam could occur.
The cutter area should be blown out with air periodically to prevent debris from building up inside the
cutter area. The required cleaning interval varies greatly depending on the quality of the ticket stock
and the amount of paper dust entering the cutter area.
If the printer will be used with ticket stock that has a thickness greater than .008” then the cutter
speed needs to be changed to SLOW. Please contact
for documentation to make this change.
If the cutter speed is not changed to SLOW, then the printer will not work reliably with said stock.
Click here to return to >
Boca Cutter
