Black Box LGB6026A, Руководство по управлению

Страница: 1216 / 1289

– 1214 –
C
HAPTER
48 | Multicast Routing Commands
PIM Multicast Routing
Table 181: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function Mode
PIM-SM Commands
ip pim bsr-candidate Configures the switch as a Bootstrap Router (BSR) GC
candidate
ip pim register-rate-limit Configures the rate at which register messages are GC
sent by the Designated Router (DR)
ip pim register-source Configure the IP source address of a register message GC
to an address other than the outgoing interface
address of the designated router (DR) leading toward
the rendezvous point (RP)
ip pim rp-address Sets a static address for the rendezvous point GC
ip pim rp-candidate Configures the switch rendezvous point (RP) candidate GC
ip pim spt-threshold Prevents the last-hop PIM router from switching to GC
Shortest Path Source Tree (SPT) mode
ip pim dr-priority Sets the priority value for a DR candidate IC
ip pim join-prune-interval Sets the join/prune timer IC
clear ip pim bsr rp-set Clears RP entries learned through the BSR PE
show ip pim bsr-router Displays information about the BSR PE
show ip pim rp mapping Displays active RPs and associated multicast routing PE
entries
show ip pim rp-hash Displays the RP used for the specified multicast group PE
router pim
This command enables IPv4 Protocol-Independent Multicast routing
globally on the router. Use the
no form to disable PIM multicast routing.
S
YNTAX
[ no ] router pim
D
EFAULT
S
ETTING
Disabled
C
OMMAND
M
ODE
Global Configuration
C
OMMAND
U
SAGE
◆
This command enables PIM-DM and PIM-SM globally for the router. You
also need to enable PIM-DM or PIM-SM for each interface that will
support multicast routing using the
ip pim dense-mode or ip pim sparse
mode command, and make any changes necessary to the multicast
protocol parameters.
◆
To use multicast routing, IGMP proxy can not enabled on any interface
of the device (see the
ip igmp proxy command).