Black Box LGB6026A, Руководство по управлению

Страница: 1107 / 1289

C
HAPTER
46 | IP Interface Commands
IPv6 Interface
– 1105 –
C
OMMAND
U
SAGE
◆
When a non-default value is configured, the specified interval is used
both for router advertisements and by the router itself.
◆
This command specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing the
reachability of a neighbor. Therefore, avoid using very short intervals
for normal IPv6 operations.
E
XAMPLE
The following sets the interval between sending neighbor solicitation
messages to 30000 milliseconds:
Console(config)#interface vlan 1
Console(config)#pv6 nd ns-interval 30000
Console(config)#end
Console#show ipv6 interface
Vlan 1 is up
IPv6 is enable.
Link-local address:
FE80::2E0:CFF:FE9C:CA10/64
Global unicast address(es):
2001:DB8:2222:7272::/64, subnet is 2001:DB8:2222:7272::/64
2009:DB9:2229::79, subnet is ::
Joined group address(es):
FF02::2
FF02::1:FF00:0
FF02::1:2
FF02::1:FF9C:CA10
FF02::1
IPv6 link MTU is 1500 bytes
ND DAD is enabled, number of DAD attempts: 2.
ND retransmit interval is 30000 milliseconds
Console#
R
ELATED
C
OMMANDS
show running-config (629)
ipv6 nd reachable-
time
This command configures the amount of time that a remote IPv6 node is
considered reachable after some reachability confirmation event has
occurred.
S
YNTAX
ipv6 nd reachable-time milliseconds
no ipv6 nd reachable-time
milliseconds - The time that a node can be considered reachable
after receiving confirmation of reachability.
(Range: 1000-3600000)