BIRD 7001A900-2, Руководство по эксплуатации

Страница: 24 / 92

Bird Diagnostic System
14
Connecting the Sensor and Receiver Cables
1. Connect the current and voltage cables to the sensor (
Figure 12 on page 13
).
Torque the SMA connectors to 4.5 in-lb (0.5 Nm).
Note: The SMA connector on the current sensor cable has a standard center conductor and the SMA
connector on the voltage sensor cable has a reverse polarity center conductor.
2. Connect the temperature/data cable to the sensor.
3. Connect the current and voltage data cables to the receiver (
Figure 13 on page 14
).
Torque the SMA connectors to 4.5 in-lb (0.5 Nm).
4. Connect the temperature / data cable to the receiver.
5. Connect receiver to external communications/control system.
a. If required, connect Ethernet cable to receiver’s Ethernet port (rear panel).
b. If required, connect cable to RS-232 connector (front panel), see
"RS-232 Serial Control" on page 78
for information about RS-232 setup/control.
6. Connect the power supply to the power connector.
7. Apply power to the receiver (rear panel power switch) and verify that the LEDs on the receiver light. See
"Status
LEDs" on page 41
for a description of the Status LEDs operation. See
"Connectors, Controls and Indicators"
on page 9
for a description of all of the receiver’s LED indicators.
Figure 13 Receiver Cable Connections from Sensor
CAUTION
Do not over tighten SMA connectors.
Over tightening can deform the connectors and adversely impact system calibration.
Item Description
1 Voltage sensor connector
2 Current sensor connector
3 Sensor temperature / data connector (DB-9)
4 RS-232 Connector
5 EtherCAT connector