FC1400 User Manual
FC1400OM-2.04 16 / 95
FC1400 Operation Manual
Electric cables and lead wires can be wiped off or cleaned with towels wet with lukewarm water,
neutral soap, or isopropyl alcohol. Using ethylene oxide for intensive disinfection (almost complete
sterilization) is allowed. Note, however, that it will reduce the lifetime of cables or lead wires. Clean the
belt using soap and water while making sure that the water temperature does not exceed 60
°
C.
NOTE
The decision to sterilize
must be made per your institution’s requirements with an awareness of
the effect on the integrity of the cable or leadwires.
NOTE
The Equipment needs safety inspection once a year. Please refer to user’s guide or service
manual.
After cleaning the equipment, carefully inspect the main body and the sensors. Do not use the
equipment if it has been damaged or if it has deteriorated.
Clean the exterior of the equipment at least once a month using soft cloth wet with tepid water or
alcohol. Do not use lacquer, thinner, ethylene, or any oxidizing agent that may cause damage to the
equipment. After verifying that there is no dust or contamination on the cables and accessories, wipe
them off with soft cloth wet with
40˚C/104˚F water. Wipe them at least once a week using clinical
alcohol.
NOTE
There is back-up battery on board inside system. Please dispose of according to all local
regulations.
Warning
Remove AC power before changing battery.
Check the electrodes of batteries before changing them.
If the installation or arrangement of the external grounding wire is doubtful, operate the equipment with
internal power.
In case the equipment is not to be used for some time, remove the primary battery if no safety problem
is expected to occur.
