Bionet BM1VET, Руководство по эксплуатации

Страница: 17 / 191

BM1VOM-1.24
1.BASIC 16
BM1VET Operation Manual
NOTES
Power Requirements
Before connecting the device to the power line, check the voltage and frequency. Ratings of the
power line are the same as those indicated on the unit’s label. If this is not the case, do not connect
the system to the power line until you adjust the unit to match the power source.
In U.S.A, if the installation of this equipment will use 240V rather than 120V, the source must
be a center-tapped, 240V, single-phase circuit.
Restricted Sale
U.S.A federal law restricts this device to sale by or on the order of a licensed veterinarian.
Supervised Use
This equipment is intended for use under the direct supervision of trained veterinary personnel in
veterinary.
Ventilation Requirements
Set up the device in a location which affords sufficient ventilation. The ventilation openings of the
device must not be obstructed. The ambient conditions specified in the technical specifications must
be ensured at all times.
·Put the monitor in a location where you can easily see the screen and access the operating controls.
·This product is protected against the effects of cardiac defibrillator discharges to ensure proper
recovery, as required by test standards. (The screen may blank during a defibrillator discharge but
recovers within second as required by test standards.)
Interpretive Results
Interpretive results are intended only as guidance for the qualified physicians and must not be relied
upon as diagnoses.
Reference Literature
Medical Device Directive 93/42/EEC
EN 60601-1/1990 +A1: 1993 +A2 : 1995 : Medical electrical equipment.
General requirements for safety
EN 60601-1-1/9. 1994 +A1 12.95: General requirements for safety.
General Precautions on Electrical Safety
Warning
Check the item listed below before operating the equipment
1. Be sure that AC power supply line is appropriate to use. (AC100 - 240V)
2. Be sure that the power source is the one supplied from Bionet. (DC15V, 2.0A)
3. Be sure that the entire connection cable of the system is properly and firmly fixed.
4. Be sure that the equipment is completely grounded. (If not, this might cause a problem to occur in
the product.)
5. The equipment should not be placed in the vicinity of electric generators, X-ray, broadcasting
apparatus to eliminate electrical noise during operation. Otherwise, it may cause incorrect result.
Note