I
NSTALLATION
C
OMFORT
A
IR
C
URTAIN
22
2.7.5 Connecting external controls to unit (optional)
The terminals are located in the connector plate on the top of
the unit. The corresponding connectors are located in the ter-
minals.
•
Connect the output signal cable to terminal
3
.
•
Connect the input signal cable to terminal
4
.
Note:
n
Allow some 30 cm excess cable length: it will be needed to
take the electronics out when servicing the unit.
2.8
Finishing the unit
2.8.1 Finishing free-hanging models
Fitting end panels
1. Fit the end panels to either side of the unit:
-
Hook the end panels
1
into the key holes in side
2
.
-
Push the panels down until you hear a click.
If linking two or more units to each other, fit the end
panels to the outer ends.
Fitting inlet grates
2. Fit the inlet grates to the unit:
-
Hook the grates onto the upper side of the unit.
-
The back of each grate has a projection. Fit the grate
with the projection into the rectangular hole
3
.
2.8.2 Finishing recessed models
General
Note:
n
Ensure that the unit remains accessible for maintenance
and repair through, for instance, an inspection hatch.
3
4
1
2
3