BELL LABS INNOVATIONS Lucent Technologies MERLIN MAGIX, Установка, СПМ, обслуживание и дополнение по устранению неполадок

Страница: 253 / 280

Board Renumbering with the 016 MLX Module
8-75
System Programming Maintenance
Adding a 016 Module at the End of an
Existing System
8
Follow these steps when you are adding a 016 MLX module to the end of an
existing system:
1. Back up the system programming to the customer backup card. Use a
filename that describes the pre-016 MLX configuration-for example, “pre-
016 MLX.”
2. Print a System Setup report. Determine whether the last slot/slots are
programmed with phantom modules. If there are phantom modules, the
programming for these modules will be removed when the new 016 MLX
module is implemented.
3. If no phantom modules are programmed, go to Step 4. If there are phantom
modules, print all Extension Information reports for the extensions and
MFMs connected to the phantom modules. The extensions must be re-
programmed after the new 016 MLX module is implemented.
4. Power down the system and install the 016 MLX module in the next
available slot.
5. Power up the system.
6. Perform a Board Renumber procedure (
Sys Program
( )
→
System
→
( )
→
Board Renum
( )
→
Yes
( ).
7. Print an Extension Directory report to verify the new extension numbers on
the 016 MLX module, and program as necessary to meet customer needs.
8. If phantom modules were programmed, re-program the phantom modules,
as needed using the information in the Extension Information reports
printed in Step 3.
9. Back up the system to a new filename to keep the first backup intact. Use a
filename that describes the post-016 MLX configuration-for example, “post-
016 MLX.”