15
Kaleido-X
Release Notes
Kaleido-X (14RU) Expansion
•
[Ref. #20766]
After changing the frame rate for an expansion system, it may happen that
the GPI/Genlock card status information displayed in XAdmin does not reflect the new
frame rate.
Workaround:
Reset the GPI/Genlock card (either by pressing the Reset button on the
front of the card, or by clicking the
Reset
button at the end of the card heading row in
XAdmin’s
Status and Options
page). If there is no valid reference signal connected to
the GPI/Genlock card input, then you may need to physically reseat the card.
•
[Ref. #17264]
If an expansion card is removed from, and then reinserted into Frame A,
video output from a KXO card on Frame A may become corrupted if that KXO card is
being fed by inputs from Frame B.
Workaround:
Press the reset button on the Frame A expansion card.
•
[Ref. #17844]
On rare occasions, after an expansion card is inserted into a Kaleido-X
frame, Dolby E audio embedded in a video signal is lost when routed to a monitoring
output.
Workaround:
If the audio monitoring out for Dolby E stops working after inserting an
expansion card, reseat both the associated input and output cards. The audio should be
restored.
•
[Ref. #18329]
If the expansion card in Frame A is removed, an upgrade message appears
in the dashboard: “Firmware upgrade cannot proceed until legacy KXO (<3.00) are
removed from frame B”.
Workaround:
Before removing an expansion card, power down the frame. Note that
removing an expansion card will affect the behavior of the expansion system. Refer to
the “Kaleido-X (7RU) Expansion” chapter in the
Kaleido-X (7RU) Hardware Description &
Installation Manual
for more information.
Kaleido-X (4RU, 7RU)
•
[Ref. #25919/T100345]
Kaleido-X (4RU) networking setup:
When the
Output A
card has the
master status in a Kaleido-X (4RU) system, it is not possible to change the IP address for
both output cards at the same time in XAdmin.
Workaround:
Change the IP address for one output card, apply this change, and then
change the IP address for the other card.
All Multi-Viewer Models
•
[Ref. #30283]
Kaleido-X16, Kaleido-X (4RU), Kaleido-X (7RU):
If your multi-viewer is
configured for half-duplex communication, and you wish to set it back to auto-
negotiation mode, you may need to power cycle the multi-viewer, for the change to be
effective.
•
[Ref. #26874]
Swapping port assignments:
Swapping the port assignments between
two tally devices connected to a multi-viewer over a TCP/IP or UDP/IP network, and
configured in XEdit, may result in a nonfunctional system.
Workaround:
If you need to interchange the network port assignments between two
devices in XEdit, first disconnect both devices from the multi-viewer as follows:
1 In the
Interconnects
tab, click the link between the device and the multi-viewer,
and then, in the
Properties
pane, set the
Transport type
attribute to
“Disconnected”.
2 Save the system.
