Belden GRASS VALLEY KALEIDO Series, Инструкция по установке и обслуживанию

Страница: 73 / 128

73
Kaleido - IP X320/X120
Installation & Service Manual
Using a Kaleido-RCP2 with Default Settings
By default, the Kaleido-RCP2 is configured with DHCP enabled, so it will automatically be
assigned an IP address by a DHCP server. If no DHCP server can be found, the Kaleido-RCP2
will fall back to its default static IP address, subnet mask, and gateway settings:
If you need to operate with a fixed IP address, you must use the Kaleido-RCP2’s
configuration menu to disable DHCP and set up the correct IP address, Network Mask, and
Gateway (see the “Enabling or Disabling DHCP” and “Setting an IP Address, Subnet Mask
and Gateway” sections in the Kaleido-RCP2 Guide to Installation and Operation , available
from the Documentation Library section of Grass Valley’s website).
To access Kaleido-X rooms located in other subnets, the Kaleido-RCP2 must be configured
with the appropriate unicast IP addresses (see the “Configuring Unicast IP Addresses”
section in the Kaleido-RCP2 Guide to Installation and Operation , available from the
Documentation Library section of Grass Valley’s website).
To start using the Kaleido-RCP2 with its default settings
1 On the Kaleido-RCP2 unit, press the ENTER button and hold it until the ESC button
lights up.
The following message appears on the LCD display:
Configuration
ROOM SELECTION
2 Press ENTER again to obtain the room list from the multiviewers that are currently
available on the network.
The message
ROOM Select
followed by the name of the first room available appears on
the LCD display.
3 Press the 2 key (to move up in the list) or the 8 key (to move down the list) until the
name of the room you wish to access is displayed.
4 Press ENTER, and then press ESC to exit the configuration menu.
5 Press the LOGIN button.
The following message appears on the LCD display:
LOGIN Position
Admin
6 Press ENTER to log on to your system as Admin.
A message prompting you for a password appears on the LCD display.
7 Press ENTER again (by default, there is no password).
The message Access granted will appear on the LCD display if the login is successful. If
a mouse is connected to the Kaleido-RCP2, then you should be able to see and move
the mouse pointer on the monitor wall.
Default IP address 10.0.3.191
Default subnet mask 255.255.0.0
Default gateway
0.0.0.0