Belden GRASS VALLEY KALEIDO Series, Инструкция по установке и обслуживанию

Страница: 34 / 128

34
IP Network Setup
Configuring a Multiviewer’s IP, Date, and Time Settings with XAdmin
3 Under General , type a descriptive name for your system to make it readily identifiable.
If there are more than one multiviewer in the same network environment, it is
important to assign each a unique system name, so that you can tell them apart (for
example, when using a remote control panel such as the Kaleido-RCP2 or RCP-200).
4 Under Ethernet , type the appropriate IP addresses, network masks, and gateway
settings, and review the detected connection speeds and duplex modes for your
Kaleido - IP’s network adapters. Certain configurations require further specific
configuration procedures to be followed.
Note:
The system name must comply with RFC 1123, because it is also used
as the device’s host name. Up to 8 characters are allowed, limited to A-Z, a-z,
0-9, and the hyphen character. The system name cannot start or end with a
hyphen character.
To implement For further information, see also
SMPTE ST 2022-6 /
2110 Inputs
Configuring Uncompressed IP SMPTE ST 2022-6 / 2110 Inputs , on
page 83
SMPTE ST 2110-20
output(s)
Configuring Head Streaming , on page 84
SMPTE ST 2022-7 Cabling and Configuring the Head Streaming to support
SMPTE ST 2022 - 7 Redundancy , on page 88
NMOS
AMWA IS-04
and IS-05 for use
with SMPTE ST
2110 streams
Configuring the Kaleido - IP to use SMPTE ST 2022-6 / 2110 Inputs
and ST 2110 Outputs with NMOS , on page 92