Belarus 2122.6, Руководство оператора

Страница: 9 / 248

2122.6-0000010 OM
9
Introduction
The present manual is designed for studying the structure, operation rules and
maintenance of tractors “BELARUS-2122.6”.
Scrutinize this manual. It will help you to study the rules of correct operation and
maintenance.
Failure to follow these instructions can lead to operator's injury or a tractor break-
down.
Tractor operation, its maintenance and repair shall be carried out only by employ-
ees, familiar with all of its parameters and characteristics and informed about necessary
safety requirements to prevent casualties.
Due to constant tractor development, some changes which are not specified in the
present manual can be introduced in the structure of certain units and parts.
Any arbitrary changes made by a consumer release the manufacturer from respon-
sibility for possible further injuries to the operator and a tractor breakdown.
Adopted abbreviations and conventional notations:
ADL – automatic differential lock;
AB – accumulator battery;
DL – differential lock;
RADL – rear axle differential lock;
PLU – pilot lamps unit;
FB – fuse block;
OPU for HLL – operation programming unit for hydraulic lift linkage;
FC – fast coupling;
PTO – power takeoff shaft;
PRS – power reception shaft;
HSC – hydrostatic steering control;
HLL – hydraulic lift linkage;
HS – hydraulic system;
FFVS – frequency fuel volume sensor;
STM – shift-time maintenance;
RPTO – rear power take-off shaft;
SPTA – spare parts, tools and accessories;
RA – rear axle;
RLL – rear lift linkage;
II – integrated indicator;
GB – gearbox;
HPC – heating plug controller;
CECS - complex electronic control system;
MI – multifunction indicator;
MTU – machine and tractor unit;
CC – coupling clutch;
LL – lift linkage;
CL – coolant;
IAC – inlet air cooler;
FDA – front driving axle;
FPTO – front power take-off shaft;
FLL – front lift linkage;
FDAD – front driving axle drive;
IICP – integrated indicator control module;
IEB – integrated electronic board;
HPH – high pressure hoses;
HP – heating plugs;
SM – seasonal maintenance;
SPU – switching and protection unit;
MS – maintenance service;
MS1 – maintenance service No1;
MS2 – maintenance service No2;
https://tractormanualz.com/