2122.6-0000010 OM
84
To connect coupled electrical equipment from the sockets, mounted in the cab, it is
required to remount plank 4 (figure 2.25.3) in the following way:
- remove four caps 1, unscrew four bolts 2, remove plank 4 from openings A;
- take the harness from the socket (or sockets) out of the cab through a formed rec-
tangular opening;
- mount plank 4 onto openings
Б
, as shown below in view b) of figure 2.25.3, the har-
ness from the socket shall go out of the cab through opening B;
- screw in bolts 2 with the torque from 8 to 10 N•m, mount caps 1 onto the bolts.
а
) plank initial position
b) plank position when connecting
coupled electrical equipment
1 – cap; 2 – bolt; 3 – cab rear side; 4 – plank.
Figure 2.25.3 – Plank remounting on cab rear side for socket wires outlet
Note – It is allowed to carry out connection of electrical equipment for coupled im-
plements to tractor alternator.
- terminal “+” to alternator terminal “B+”;
- terminal “-“ to engine housing.
ATTENTION: WHEN CONNECTING ELECTRICAL EQUIPMENT OF COUPLED
IMPLEMENTS TO TRACTOR, CONSULT YOUR DEALER, AS WRONG CONNECTION
OF ELECTRICAL EQUIPMENT FOR COUPLED IMPLEMENTS TO TRACTOR CAN
CAUSE FAILURE OF TRACTOR ELECTRICAL EQUIPMENT!
https://tractormanualz.com/
