Beko DRYPOINT AC 410, Инструкция по установке и эксплуатации

Страница: 10 / 56

Installation and operating manual
EN
10 DRYPOINT
®
AC 410 – 495 | DRYPOINT
®
AC 410 – 495 MS
1.3.4. Safety instructions for maintenance work
All persons involved in the installation, start-up, operation or maintenance of the plant must have read and fully
understood the installation and operating instructions, and in particular the safety instructions. If you have any
queries, please contact the manufacturer.
The manufacturer shall not be liable for damage caused by incorrect installation, assembly or start-up of the plant.
The plant operator shall be solely responsible for such damage.
The responsibilities for maintenance work must be clearly assigned. Before carrying out any maintenance work,
inform the operating personnel.
All prescribed configuration, maintenance and inspection tasks must be carried out by customer service technicians
of the manufacturer and according to the schedule.
Strictly adhere to all instructions regarding the maintenance of the plant.
DANGER Maintenance work during plant operation
Carrying out maintenance work while the plant is in operation poses an increased risk to
persons.
• For certain maintenance tasks, the plant must be completely shut down, de-energized
and depressurised.
• Shut down the plant, following the relevant instructions.
• Depressurise the plant.
• Disconnect it from the electric power supply, secure it against inadvertent switching on
and attach a warning sign
• to the main switch.
• If guards need to be removed, let the plant cool down before carrying out any further
work. Before restarting the plant, mount and secure the guards and insulation.
DANGER Improper replacement of components
Incorrect replacement of components can cause serious or even fatal injury.
• We strongly recommend having damaged or wearing parts replaced by a customer
service technician of the manufacturer.
• After completion of the maintenance work, perform a leakage test.
• To replace large assemblies, use lifting gear and secure the parts properly before moving
them! Use only lifting gear lashing equipment that is in proper working order and has the
necessary load capacity!
DANGER Assembly work above head height
Assembly work above head height can cause serious or even fatal injury.
• For all such work, use safety-approved ladders and work platforms!
• Never use machine parts as climbing aids! Risk of injury from fall!
• For all maintenance work above a height of 1.80 m, wear fall arrest equipment!
NOTE Use of unsuitable or damaged components
The use of unsuitable or damaged components can cause malfunction of the plant.
• If you detect any serious damage to the pressure devices, shut them down and remove
them immediately!
• Replace damaged components with new ones.
• Replace wearing parts according to the prescribed schedule in the devices and spare
parts list or in chapter “7.2. Maintenance schedule”. This list is an integral part of these
installation and operating instructions.
• Use only original spare and accessory parts supplied by the manufacturer. Third-party
components might not meet the necessary stress and safety standards.