16.1 To remove the fascia.
Amour, Aspect, Aspect Glass, Eclipse, Tranquility
and Fascination models.
1. Eclipse model only-
Remove the upper fascia trim,
side fascia trims and lower fascia trim. These are
held by magnets.
2.
The fascia is held in place by four retaining plates
at the back of the fascia. These slot into four retaining
brackets on the hotbox. To remove the fascia, hold
the sides of the fascia and lift upward and forward.
The fascia should lift clear of the hotbox (See figure
41)
3.
Replace in the reverse order
Landscape, Visia
and Serenity
models
1. Visia model only.
There is a heat baffle
that is screwed to the
fascia and spillage
plate (See figure 42).
Unscrew and remove
this heat baffle.
2.
Remove the two
screws from the base of the fascia (See figure
43).
3.
Support the fascia and release the two screws
from the top of the spillage plate. Do not remove
the screws but release them sufficiently to allow
the fascia to be lifted off. Lift the fascia clear of
the hotbox.
Page 38
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 43. Fascia removal
Figure 42. Fascia heat baffle location
Figure 41. Fascia removal
(The fascia may differ from
that shown)
