14.2 Fitting the Landscape, Visia and Serenity fascia.
1.
Supplied with the fire are two
fascia securing brackets and two
machine screws. Secure the
brackets to the hotbox using the
machine screws supplied (See
figure 31).
2.
Insert two black self tapping
screws into the holes at the top
of the spillage plate leaving
about 1.5mm gap between the
underside of the screw head and
the spillage plate (See figure 32)
3.
At the top of the fascia there are two cut-
outs. Locate the cut-outs on to the screws at
the top of the spillage plate (See figure 33).
4.
The lower inner sides of the fascia should
sit on top of the fascia securing brackets. The
fascia will need to be re-positioned if the
fascia sides fall behind the brackets (See
figure 33). Secure the fascia using two self
tapping screws supplied (See figure 33)
5.
Tighten the two screws in the
top of the fascia.
6.
Serenity model only -
Where fitted, remove the
protective film from the fascia
trims.
7.
Visia model only -
Supplied with the fire is a heat
baffle. This baffle must be fitted
to the underside of the spillage
hood.
!
Secure the baffle to the
underside of the spillage hood
using the two screws supplied (See figure 34).
!
Secure the baffle to the fascia using the two screws supplied. The centre hole does
not require a screw (See figure 34).
Page 32
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 33 Fascia securing.
Figure 32 Screw location.
Figure 31 Fitting the fascia securing brackets (The
bracket design may differ from that shown).
