Carefully remove all the contents. Take special care in handling the ceramic fuel effects.
Check that all the listed parts are present and in good condition. The pack may contain
additional components to that stated above. These can be discarded.
6. FIREPLACE CHECK
6.1 Fireplace check.
6.1.1
Fireplace size
The fireplace must comply with the requirements described in section 4.2. This will
probably entail removing the fireback and infill material behind the fireback. The debris
catchment area shown in figure 7 must be kept clear of obstructions.
6.1.2
Fireplace general
condition
The fireplace floor should be
reasonably flat to ensure that the
hotbox can be installed without it
rocking and so that a good seal
can be made at the bottom front
of the box. The front face of the
fireplace should be reasonably
flat over the area covered by the
hotbox top and side flange seals
to ensure good sealing. These
faces should be made good if
necessary. If the appliance is to
Page 18
INSTALLER GUIDE
©
Baxi Heating U.K. Limited 2007.
Figure 6. Pack contents continued
Figure 7. Fireplace area
