Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 96 / 120

Storage conditions
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04 Baumüller Nürnberg GmbH
96
of 118
17.4
8 Pull (by hand) the orange handle on the right part of the power supply further forward
and then pull the module block forward, thus removing it from the 35 mm C-rail.
The module block comprises the power supply, the b maXX safe PLC and, if applica-
ble, additional system components for the b maXX safe PLC.
9 Disconnect the b maXX safe PLC from the power supply by actuating the disconnec-
tion mechanism on the back side of the b maXX safe PLC with the screwdriver. To do
this, insert the screwdriver into the groove horizontally and then press it upwards. Now
remove the power supply from the b maXX safe PLC.
10 Place the b maXX safe PLC into the prepared packaging.
Place the power supply (if applicable) into the prepared packaging.
Place the additional system components (if applicable) into the prepared packaging
for each component in question.
11 If you want to exchange the b maXX safe PLC, now mount the new b maXX safe PLC
(see
Z
Assembly and installation
–
from page 45 onward).
12 Close the electrical cabinet.
13 Document the disassembly (or exchange) of the b maXX safe PLC module.
Document the disassembly (or exchange) of the power supply for the b maXX control-
ler/safe PLC, if applicable.
Document the disassembly (or exchange) of the additional system components, if ap-
plicable.
If you have exchanged the b maXX safe PLC, the entire system can now be switched
back on. If you wish to dispose of the module, you will find further information in chapter
Z
Disposal
–
from page 97 onward.
17.4 Storage conditions
Store the b maXX safe PLC module in a suitable package under the storage conditions
specified in the
Z
Appendix D - Technical data
–
from page 109 onward.
17.5 Recommissioning
If you want to put the b maXX safe PLC module back into operation, observe the specifi-
cations under “Storage conditions”. Then conduct the
Z
Commissioning
–
from page 59
onward again.