Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 77 / 120

Commissioning
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04
77
of 118
11
11.9.5 Description and inspection of the operating and display elements
The BMC-M-CFI-01 module has eight LEDs (five green [H1, H5, H6, H7, H8)] a red one
[H2], a yellow one [H3] and a red/green [H4]) (see “F” in
Z
Figure 4
–
on page 38).
Figure 18: LEDs of the BMC-M-CFI-01 CF module
The S1 button (see “H” in
Z
Figure 4
–
on page 38) is located below the LEDs. This is used
to start data transfers.
Below that is the S2 rotary switch (see “J” in
Z
Figure 4
–
on page 38) for setting the indi-
vidual values of the code.
NOTICE!
The standard PLC and the safety PLC will continue to run in the entire processing
process, meaning that the online communication will also be running.
NOTICE!
Once the project has been copied to the memory card during only the residual time
of the control, the procedure can take considerably longer than in running up or when
the control is in “STOP” status. If you want to copy the project to the memory card in
“RUN” status, care must be taken that sufficient reserves still remain between the
safety cycle time set and the actual amount of execution time needed, especially with
the safety PLC.
The execution time is displayed in the safety PLC on diagnostic flags and should not
exceed 95% of the parameterized safety cycle time for long periods of time (see Ap-
plication Handbook b maXX safe PLC).
LEDs
H1
⊗
green
⊗
red
⊗
yellow
H4
⊗
/
⊗
green/r
ed
not used in connection with the
safety control.
H5
⊗
green
⊗
green
⊗
green
H8
⊗
green
indicates the digit during code entry