Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 55 / 120

Assembly and installation
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04
55
of 118
9
9.6.5 Installation procedure
h
Make sure that the power to the b maXX System has been switched off.
h
Make sure that the external power supply has been shut off and is secured from being
switched back on.
h
Connect the 9-way SUB-D jack X1 to the front plate of the left part of the b maXX safe
PLC with the PROPROG programming cable (for more on this, see
Z
Requirements on
the connection cable
–
on page 54 and
Z
Appendix D - Technical data
–
from page 109
onward).
h
Connect the 9-way SUB-D jack X2 to the front plate of the left part of the b maXX safe
PLC with the connection cable for a terminal or another device with the RS485 inter-
face (for more on this, see
Z
Requirements on the connection cable
–
on page 54 and
Z
Appendix D - Technical data
–
from page 109 onward).
Figure 14: Cable routing
h
Route the connection lines according to the specifications in
Z
Figure 14
–
. The cable
shielding must be laid open first. The length of the exposed shielding should corre-
spond to the width of the fastening clamp. The cable is fastened with the clamp in such
a manner as to create a connection between the cable shielding and the PE of the elec-
trical cabinet.
The installation is now complete.
Uncover the shielding of
the cable and connect it with
PE of the control cabinet
Uncover the shielding of
the cable and connect it with
PE of the control cabinet