Baumuller b maXX BMC-M-SAF-02, Руководство по эксплуатации

Страница: 70 / 120

Startup and operation options with inserted memory card
Operation Manual b maXX safe PLC BMC-M-SAF-02
Document no.: 5.07020.04 Baumüller Nürnberg GmbH
70
of 118
11.9
11.8.2 Testing the functioning of the BMC-M-SAF-02 (standard PLC)
m
Two statuses can occur when the b maXX systems is switched on:
n
No boot project (= no user project on the standard PLC) present:
The LED H2 (red) will light up briefly and then the LEDs H5 (green) and H6 (red) will
light up steadily.
This means that no project is present on the standard PLC.
In "POWER ON" status, the b maXX safe PLC is waiting for PROPROG communi-
cation
n
Boot project present:
The boot project is loaded upon switching on. The upper LEDs will blink in the pro-
cess. After a short time, the LED H6 (red) will light up. The standard PLC is in
"STOP" status.
m
As long as switch/button S2 on the b maXX safe PLC is on "STOP" (middle position),
a boot project present will not be able to start up.
If you want to start an existing boot project by setting the S2 switch on the b maXX safe
PLC on "RUN" (lowermost position), make certain
before doing so that the correct
boot project for your application has been imported for this system in this b maXX safe
PLC and that the correct address has been set on the power supply (if it is being eval-
uated in your project)!
Further information on how you can ensure this or how you can conduct the “Send a boot
project” to the b maXX safe PLC can be found in the “Application Handbook b maXX con-
troller PLC”.
11.9 Startup and operation options with inserted memory card
11.9.1 Safety-related instructions on the use of memory cards
Memory cards of the b maXX safe PLC contain all configuration data, parameter data and
application data of an allocated control system. This pertains to data of the standard con-
trol as well as data of the safety control. Further explanations on the memory card data
can be found in chapter
Z
Data on the memory card
–
on page 38.
The use of a memory card is optional. The use of a memory card enables control data to
be copied onto the control and control data to be copied onto the card.
Copying memory card data onto the control is only possible when the control system is in
Stop mode. The description of the available operation modes can be found in
Z
Description of the operation modes, RUN/STOP switch
–
from page 60 onward.
CAUTION!
Memory cards may only be used as data sources in the event of repairs. Loading a
new configuration or application of the memory card is not permissible without verifi-
cation by the programming environment.