Baumuller b maXX 5000, Инструкция по эксплуатации

Страница: 217 / 330

Operation
Instruction handbook b maXX 5000
Document No.: 5.09021.16
217
of 328
8
8.4.3 CANopen
®
.
Type code b maXX 5000 with CANopen
®
:
BM5XXX-XXXX-XXXX- 03 XX-
The data can be transmitted to all the other CAN-users (e g from CANopen
®
master) via
the b maXX 5000 .
X3 and X4 are the RJ45 connections for CAN bus cables (also see Z Connections on the
front side – on page 171), which are on the front side of the device.
Mounting and

installation
The mounting / installation consists of the following steps:
1 De-energize b maXX 5000 device
2 Set address and baud rate (transfer rate) at the b maXX 5000 ,

see Z CANopen
®
– on page 103.
3 Connect b maXX 5000 with CANopen
®
-bus cables (and, if necessary, a terminated
connector).
n Comply to EMC-oriented laying of CANopen
®
connection cables!
n Baumüller released the following cables for use:

CANopen
®
connection cable;

further information see Z Accessories - CANopen
®
. – on page 250.
NOTE!
If the b maXX 5000 device is the last bus node in the line, X4 must be terminated with
a terminating connector (see Z Accessories - CANopen
®
. – on page 250).
Commissioning The following preconditions must be fulfilled before commissioning can be made:
1 b maXX 5000 with CANopen
®
is correctly installed.
n CANopen
®
-connection cables are correctly wired.
2 The control cabinet has been locked correctly and the safety devices have been put
into operation.
3 The b maXX 5000 device is ready-to-use.
Address switch By means of the address switch S1 to S4 the settings, like e.g. the baud rate (transfer
rate) and the address setting (slave No. /ID) are made

(see Z CANopen
®
– on page 103).

Further information about parameter setting of the CANopen
®
slave, see „Application
Manual“.