Baumuller b maXX 5000 BM5800 Series, Инструкция по эксплуатации

Страница: 118 / 176

Fieldbus communication
Instruction handbook b maXX 5800
Document No. 5.16027.04 Baumüller Nürnberg GmbH
118
of 174
8.3
8.3.2 VARAN .
Type code b maXX 5800 with VARAN:
BM58XX-XX-XXXXXX-XXXXXX-XXXXXX-XX 2 -
A b maXX 5800 with fieldbus option VARAN can communicate with a VARAN master.
X3 and X4 on the front side of the device are the RJ45 connections for VARAN.
Mounting and

installation
The mounting/installation consists of the following steps:
1 De-energize the b maXX 5800 device
2 Connect b maXX 5800 with VARAN bus cables (Ethernet-LAN cable from CAT 5).
3 Connect b maXX 5800 with VARAN bus cables (Ethernet-LAN cable at least CAT 5).
n X3: VARAN-In, X4: VARAN-Out.

On the first b maXX 5800 node of a VARAN line X3 is connected with the VARAN
master. X4 is connected with X3 of the next b maXX 5800 slave in the line, and so
on. The last node of a VARAN line has no connection of X4 or is connected with a
PC (tunneling of Ethernet frames via VARAN to the controller, e. g. to communicate
with ProDrive).

Each slave within the VARAN line can be addressed and parametrized via selection
of its IP address.
Figure 41: VARAN fieldbus connection
n Please, observe an EMC-compatible laying of the Ethernet connection cables!
n The following cables were released for use by Baumüller:

Ethernet connection cable;

Further information refer to Z EtherCAT
®
, VARAN, POWERLINK
®
cable – on page
142.
NOTE!
A point-to-point connection between PC (ProDrive) and b maXX 5800 VARAN slave
X4 for commissioning is possible even without a VARAN master.