Barco CORONIS 1MP, Инструкция по установке и эксплуатации

Страница: 101 / 167

Barco DPMS Screen Saver Single Source Master
102
If requested, the display will first go into Stand-By state, then
into Suspend state, and then into Off state. The properties of
DPMS states are listed in the following table:
Monitor Settings
If you have a Barco Medical Display, select “Barco Quick Start.” If
a non-Barco display is being used, select the amount of time it
takes your display to warm up via the “Monitor Setting” section.
Contact your display vendor for this warm-up time.
On Barco C
ORONIS
displays, the I-GUARD will stabilize the image
within a few seconds after the display returns to the active state
so there is no need for a warm-up time period.
Use As Logon Screen Saver
Check the box to use the Barco DPMS Screen Saver when no one
is logged into the system.
Uncheck the box to use the default screen saver when no one is
logged into the system.
Getting started with the Barco DPMS Screen Saver
The easiest way to get started is to select an existing settings
scheme and then modify it with your preferences. Settings
Table 3:
DPMS State Power Savings
Monitor Recovery
Time
On None N/A
Stand-by Minimal Short
Suspend Substantial Longer
Off Maximum Longest