B&R MAPPC800-ENG, Руководство пользователя

Страница: 191 / 396

Software • BIOS options
Section 4
Soft
w
are
191 Panel PC 800 User's Manual V 1.00
Configure SATA as
Channels
3)
You can define a SATA or PATA drive as
Primary or Secondary Device. Before PATA The SATA drives are the Primary Devices,
meaning PATA are Secondary.
Behind PATA The PATA drives are the Primary Devices,
meaning SATA are Secondary.
AHCI/RAID SATA
hot plug
4)
Hot plug support for
AHCI/RAID systems can be set here. Disabled Enables hot plug support.
Enabled Disables hot plug support.
Primary IDE Master The drive in the system that is connected
to the IDE primary master port is
configured here. Enter Opens the submenu
See "Primary IDE Master", on page 192
Primary IDE slave The drive in the system that is connected
to the IDE primary slave port is configured
here. Enter Opens the submenu
See "Primary IDE slave", on page 194
Secondary IDE
Master The drive in the system that is connected
to the IDE secondary master port is
configured here. Enter Opens the submenu
See "Secondary IDE Master", on page 195
Secondary IDE
Slave The drive in the system that is connected
to the IDE secondary slave port is
configured here. Enter Opens the submenu
See "Secondary IDE slave", on page 197
Hard disk write
protect Write protection for the hard drive can be
enabled/disabled here. Disabled Disables this function.
Enabled Enables this function.
IDE Detect Time Out
(Sec) Configuring the time overrun limit value for
the ATA/ATAPI device identification. 0, 5, 10, 15, 20, 25, 30,
35
Time setting in seconds.
ATA(PI) 80Pin Cable
Detection Detects whether an 80 pin cable is
connected to the drive, the controller or to
both.
Information:
This option is not available on the
PPC800 CPU board. Therefore this
setting is not relevant.
Host & device Using both IDE controllers (motherboard, disk
drive).
Host IDE controller motherboard used.
Device IDE disk drive controller used.
1) These settings are only possible if ATA/IDE Configuration is set to Compatible .
2) These settings are only possible if ATA/IDE Configuration is set to Enhanced .
3) These settings are only possible if ATA/IDE Configuration is set to Enhanced and Configure SATA as to IDE .
4) These settings are only possible if ATA/IDE Configuration is set to Enhanced and Configure SATA as to RAID or AHCI .
BIOS setting Meaning Setting options Effect
Table 101: 945GME Advanced IDE Configuration setting options