B&R MAPPC800-ENG, Руководство пользователя

Страница: 269 / 396

Software • Automation Device Interface (ADI) - Control Center
Section 4
Soft
w
are
269 Panel PC 800 User's Manual V 1.00
Change turn-off time for UPS
The Shutdown time can be specified in seconds under Windows UPS service . This is the
length of time that the UPS waits before switching off the power supply. When a critical alarm
occurs (e.g. at low battery level), the Windows UPS service will send a shutdown command with
the turn off delay time to the UPS and will shut down the system.
Activate UPS messages
Under B&R UPS driver , select the checkbox UPS status message . Any changes to the UPS
status will then trigger a message from the B&R UPS driver.
If the checkbox Display UPS status with UPS monitor is also activated, a new message is not
displayed for every change, but only a general message and request for you to start the B&R
UPS monitor. As long as the UPS monitor is active, no new messages are displayed.
Information:
Administer rights are required in order to display this dialog box.
Information:
This time is evaluated by the Windows UPS Service, but can not be set in the UPS
system settings of the energy options. This value should only be changed if the
system requires longer than the default setting of 180 seconds to shut down.
Caution!
The time entered must be longer than the time required to shut down the operating
system.
Information:
Shutting down the system is only reported by the Windows UPS Service. The UPS
Service also sends other messages if they are activated in the UPS system settings
energy options. These messages are only displayed when the Windows Alerter and
Windows Messenger
1)
are active and the PC is connected to a network. Additionally,
some conditions of the B&R APC add-on UPS are not detected by the Windows UPS
Service, and are therefore do not trigger messages (e.g. when there are no battery
settings on the UPS). The Windows services can be found by opening the Control
Panel and selecting "Services" from the Administrative Tools.
1) The Windows Alerter is supported starting with B&R Windows Embedded Version 2.10 or higher.