B&R MAPPC800-ENG, Руководство пользователя

Страница: 265 / 396

Software • Automation Device Interface (ADI) - Control Center
Section 4
Soft
w
are
265 Panel PC 800 User's Manual V 1.00
8.4.4 Updating UPS battery settings
1) Open the Control Center in the Control Panel .
2) Select UPS tab.
3) Under Battery settings , click on Update . Clicking on "Open" opens a dialog box.
4) Select and open the file containing the battery settings. The "Download" dialog box is
opened.
The transfer can be aborted by clicking on Cancel in the Download dialog box. Cancel is
disabled when the flash memory is being written to.
Deleting the data in flash memory can take several seconds depending on the memory block
being used. The progress indicator is not updated during this time.
Information:
• The current UPS firmware version 1.10 does not use charge end voltage, deep
discharge voltage, lifespan and deep discharge cycles.
• Lifespan is only included in version 2 (and higher) of the UPS battery settings
and only valid for B&R UPS batteries at 25°C ambient temperature.
• Deep discharge cycles are only included in version 3 (and higher) of the UPS
battery settings and only valid for B&R UPS batteries.
Information:
If you would like to change the current battery settings on the UPS, they must first
be saved in a file.
Caution!
• The UPS cannot be operated while updating the battery settings.
• If the transfer is interrupted, then the procedure must be repeated until the
battery settings have been updated successfully. Otherwise battery
operation will no longer be possible.
Information:
The UPS is automatically restarted after a successful download. This can cause a
brief failure in the UPS communication.