VELCORP
AI-LC-1EY-HGS-( ) revision: 24 March 2014
GEMS
VELS
®
VIRGINIA ELECTRONIC & LIGHTING LLC [VELCORP]
VELCORP/GEMS OFFICES
•
1293 Energy Cove Ct
•
Green Cove Springs
•
FL
•
32043
•
USA
PHONE
•
904-230-2840 FAX
•
904-230-2938
•
•
www.velcorpgems.com
Assembly Instruction for
LC-1EY-HGS-(R,A,G,B,W)
SUBASSEMBLY / PACKAGE CONTENTS: LC-1EY-HGS-(R,A,G,B,W)
(red or amber or green or blue or
white LED)
•
O-Ring, 2 inch
•
O-Ring, 2 3/8 inch
•
LED subassembly, 2 wire, which includes: SA-SS1 socket assembly, and HGS-(White, Red, Amber,
Green, Blue) LED
•
Nut, Mounting, 2 3/8 inch
•
Nut, Flange, grey, 2.5 inch
•
Drawing LC-1EY-HGS
PROCEDURE:
1) Prepare mounting hole in instrument housing, as required, with 2 3/8” diameter carbide cutter (not
provided, GEMS Part Number IL-CHC2), remove burrs.
2) Begin disassembly of package from rear. Remove grey flange nut.
3) Remove LED subassembly from lens.
4) Unscrew 2 3/8” flange nut from lens.
5) Prepare 2.4”-2.5” mounting hole in the building at desired location if one is not present.
6) Insert lens into hole aligning it so the rib on the rim of the lens is at the top position and the fish eye
lens is in a vertical position.
7) Secure the lens in position using the 2 3/8” mounting nut and seal the O-Ring against the outside of
the building.
8) Insert the LED subassembly unit into the lens.
9) Hold the unit in place by finger tightening the grey socket flange nut, usually about one turn onto the
back of the lens.
10) Check LED assembly outside of the lens surface to assure the LED is visible through the fish-eye lens.
11) Attach the white wire to the “plus” side of the battery bus, and the black wire to the “minus” side of the
battery bus (SYSTEM GROUND).
12) TEST: Turn the AC or DC power on and check to see the LED unit is illuminated (steady light).
