Bandit
Copyright 1/07
PAGE 0
MODEL 3400T
CUTTER WHEEL SECTION
There are forty-eight (8) teeth to a complete set on a
model 3400T. Two (2) straight teeth, twenty-three (23)
left 45° teeth, and twenty-three (23) right 45° teeth.
Do Not operate machine with extremely worn or
broken teeth.
DO NOT OPERATE MACHINE WITHOUT A FULL SET OF TEETH. OPERATING MACHINE WITHOUT A
FULL SET OF TEETH CAN CAUSE EXCESSIVE VIBRATION AND PREMATURE BEARING FAILURE.
A locking pin is provided to hold the cutter wheel
in position during tooth removal and reinstallation.
Locking pin will only lock on outer teeth.
NEVER
USE HAND ON CUTTER WHEEL TO HOLD IN
PLACE WHILE CHANGING TEETH. BE SURE TO
REMOVE LOCKING PIN BEFORE OPERATING
THE MACHINE.
TOOTH ARRANGEMENT
Inspect pockets, teeth and bolts for damage and
replace as required.
When replacing pockets, always replace new pockets
across from each other (180
°) in order to prevent
vibration.
Replacement teeth must be carbide tipped and of like
design as provided with the machine.
Use anti-seize on threads to help prevent bolts from
“freezing up” in cutter wheel pockets.
When replacing complete set of teeth, be sure to
duplicate original factory tooth arrangement.
Torque bolts to 10 ft.-lbs. (0 Nm).
Straight teeth are mounted in
TWO OPPOSING
POCKETS
(180
°).
A straight tooth must have a 45° tooth accompanying
it in the same pocket set. The opposite pocket sets
should have this same combination of straight and
45° teeth, except with positions reversed. Mounting
these teeth opposite each other on the cutter wheel
reduces damaging vibration.
Two Remaining Outside Pockets require 45° teeth
overlapping the center line of the cutter wheel to make
plunge cuts possible. Mount two left 45° teeth opposite
two right 45° teeth.
All Inside Pockets require 45° teeth mounted away
from the cutter wheel.
MODEL 3400T
Straight Tooth:
900-9903-82
Left Tooth 45°:
900-9903-83
Right Tooth 45°:
900-9903-84
C’Bored Mounting Block:
900-9903-85
Threaded Mounting Block: 900-9903-86
Bolt:
900-9903-81
Tooth Kit:
900-9903-89
CUTTER WHEEL SECTION
Use only original equipment manufacturer’s teeth. The use of any other aftermarket teeth may cause damage
or premature failure to the drive train.
Содержание 3400T
Страница 44: ...Bandit Copyright 1 07 PAGE 44 MODEL 3400T NOTE Parts may not be exactly as shown UPPER FRAME COMPONENTS...
Страница 46: ...Bandit Copyright 1 07 PAGE 46 MODEL 3400T NOTE Parts may not be exactly as shown CUTTER WHEEL COMPONENTS...
Страница 48: ...Bandit Copyright 1 07 PAGE 48 MODEL 3400T NOTE Parts may not be exactly as shown FRAME COMPONENTS...
Страница 56: ...Bandit Copyright 1 07 PAGE 56 MODEL 3400T SERVICE RECORD DATE DESCRIPTION AMOUNT SERVICE RECORD...
