Bandit 3400T, Руководство пользователя

Страница: 24 / 56

Bandit
Copyright 1/07 PAGE
MODEL 3400T
DAILY START UP & MAINTENANCE cont.
7) Check cutter teeth bolts:
All cutter teeth bolts must be factory approved.
Bolts must be replaced after a maximum of 4-5
rotations/changes to insure safe clamping ability.
Torque to 10 ft.-lbs. (0 Nm) AT ALL TIMES.
8) Grease bottom pivot bushings:
Grease bottom pivot bushing with 1 to shots of
EP-2 Lithium type grease. Wipe off excess grease.
Excessive grease will attract dirt.
9) Check hydraulic oil level:
The hydraulic oil reservoir tank level should always
remain at 7/8 full. Remember to check DAILY to avoid
excessive heat build up.
10) Check for any fluid leaks:
Inspect for any oil, fuel, or hydraulic oil. Check all
hoses, fittings, lines, and tanks. DO NOT use fingers
or skin to check for hydraulic leaks. Repair or replace
any damaged or leaking components.
11) Check the fuel level:
Check the fuel level, running out and repriming is time
consuming. Do not over fill, and you must leave fuel
expansion space in the top of the tank.
12) Inspect, adjust, and lubricate tracks:
Inspect, adjust, and lubricate tracks as needed per
track MFG. manual.
13) Check engine oil and coolant levels:
Follow the engine manufacturer manual
recommendations for fluid levels. You MUST follow
specific ENGINE MFG. manual recommendations for
radiator coolant, additives, lubrication, correct engine
speed, ETC.
14) Check radiator, debris screen:
Thoroughly clean radiator fins at least once a day and
twice in excessive condition. Make sure debris is not
packed between fins. Use pressurized water spray to
clean. Do not rely on air pressure. The radiator will
only appear to be clean. A partially plugged radiator will
not allow the engine to cool properly. Clean cooling fan,
shroud on air cooled engines, and the debris screen
(if so equipped). Improper service, maintenance, or
neglect will cause overheating problems and engine
failure.
15) Check oil cooler:
Thoroughly clean cooler fins at least once a day and
twice in excessive condition. Make sure debris is not
packed between fins. Use pressurized water spray to
clean. Do not rely on air pressure. The oil cooler will
only appear to be clean. Clean cooling fan and make
sure operating correctly.
16) Check air cleaner or precleaner:
Clean or replace element following engine manual
recommendations.
17) Check around machine:
Check around the entire machine for tools, cans,
saws, etc. All tools not in use should be stored in a
tool box.
18) Review all safety procedures on decals, from
manual, and from video.
19) Make sure all safety equipment is being worn:
Make sure you are wearing all of your safety equipment:
hard hat, face shield, gloves, eye protection, ear
protection, etc. per ANSI and OSHA standards.
20) Remember to check EVERYTHING on the
checklist.
MAINTENANCE SECTION
WEEKLY MAINTENANCE
3) Check and retighten tank mount bolts:
Check the fuel tank and hydraulic tank mount bolts
and retighten.
4) Check alternator and fan belts on engine
(as applicable):
Adjust and maintain per the engine manufacturer’s
manual.
1) Grease cylinder lug pins:
Grease cylinder lug pins with 1 to shots of EP-
Lithium type grease. Wipe off excessive grease.
Excessive grease will attract dirt.
2) Grease upper frame pivot bushings:
Grease upper frame pivot bushings with 1 to shots of
EP-2 Lithium type grease. Wipe off excessive grease.
Excessive grease will attract dirt.