Bandit 3400T, Руководство пользователя

Страница: 23 / 56

Bandit
Copyright 1/07 PAGE
MODEL 3400T
DAILY START UP & MAINTENANCE
1) Check the safety decals and engine gauges:
Replace any missing or damaged decals and/or engine
gauges.
2) Check all safety equipment:
Check for proper operation. Repair or replace as
needed.
3) Check entire machine for loose bolts, nuts,
parts, or components:
Check entire machine for any loose parts or components.
Check for loose nuts or bolts. Torque, tighten, or
replace any of the loose components. See page 8
for specific bolt torques.
4) Check all guards:
Check to make sure all guards are in place and
installed correctly. Make sure they are secure.
5) Check the cutter wheel and pockets for wear:
Check for elongated bolt holes, secure welds, torqued
bolts, excessive wear and impact cracks. If a problem
is found contact the grinder manufacturer or an
authorized Bandit dealer.
6) Check condition of cutter teeth and hardware:
Grind or replace your cutter teeth to keep them sharp.
Check the condition of your teeth hardware. Replace
if necessary.
MAINTENANCE SECTION
The Bandit is a very simple machine to maintain. If you will follow a regular scheduled preventative
maintenance program you should have years of trouble free operation.
Before attempting any type of maintenance disengage clutch, turn off engine, wait for the cutterwheel to
come to a complete stop, install the cutter wheel lock pin, place cutter wheel on the ground, disconnect
battery, and make sure the ignition key is in your possession.
Consult your engine manual for proper break-in procedures. Various engines require somewhat
different procedures, but basically the engines need to operate at lower R.P.M.’s and loads for a
specific time.
Failure to properly break-in your engine will result in poor bearing and piston ring surfaces.
The Bandit has only been run for a short time to test proper hydraulic pressures, possible leaks, etc.
The fuel tank will be empty. Fuel is provided through a small auxiliary tank for testing. This immensely
helps maintain safety in our manufacturing facility and while shipping.
Do not let anyone operate or maintain this machine until they have thoroughly read this manual,
reviewed the equipment decals, watched the equipment video, and has been properly trained. You
can purchase additional Bandit manuals, decals and videos for a nominal fee.
Expensive damage to the Bandit will occur if proper preparation is not taken before welding on the
machine. Be sure to disconnect both battery cables and the engine ECM (engine control module)
before welding. Follow the specific Engine MFG. instructions for proper welding and grounding
procedures, before attempting to weld on the machine. If welding on the machine, do not ground the
welder through the machine bearings, ground near work to be performed.
MAINTENANCE SECTION
DANGER
NOTICE
DANGER
NOTICE
NOTICE
NOTICE