Bandit 3400T, Руководство пользователя

Страница: 28 / 56

Bandit
Copyright 1/07 PAGE 8
MODEL 3400T
BOLT TORQUE CHART
(THESE TORQUES ARE BASED ON DRY, CLEAN THREADS)
DESCRIPTION BOLT SIZE TORQUE (FT.-LBS.) TORQUE (Nm)
Cutter Wheel To Hydrostatic Motor Bolts M0 - . 60 8
Hydrostatic Motor To Upper Frame Bolts M12 - 1.75 75 - 80 102 - 108
Engine Hold Downs 1/”-1 NC 9 19
Cutter Wheel Teeth Bolts /8”-18 NF 10 0
Before tightening bolts be sure you have the correct size bolt for the correct amount of torque.
Use only factory approved bolts and hardware.
MAINTENANCE SECTION
PAINT CARE
To help keep up the appearance of your Bandit Equipment and reduce the possibility of surface
rust follow these steps:
1) The machine should be washed on a regular basis with a non-abrasive mild detergent and
then rinsed thoroughly. Do not pressure wash sensitive areas like: decals, gauges,
electronic devices, etc.
2) If a stone chip, paint scratch, or paint crack occurs - it should be repaired immediately.
Simply sand the edges of the damaged paint area, mask off the surrounding area and apply
primer and paint to the dry, clean, and warm surface. This will help keep the damaged area
from spreading or getting worse.
3) If you are unable to sand and mask the area, there are containers of primer and paint
available. A small brush can be used to touch up the area.
4) Also, primer and most colors of paint are available in aerosol spray cans to simply spray
over the effected area after it is cleaned, dry, and warmed. This method is not as reliable as
the process in step #.
It is also reported that some equipment owners polish their machine at least yearly and keep
good mud flaps on their towing trucks.
MAINTENANCE SECTION