Bandit 3400T, Руководство пользователя

Страница: 19 / 56

Bandit
Copyright 1/07 PAGE 19
MODEL 3400T
MACHINE OPERATION
• Check all fluids before starting the machine.
• Make sure to go through the daily start-up and maintenance procedures before operating the machine.
See pages - .
• Drive belts (if equipped) must be disengaged before starting.
• Make sure the cutter wheel switch is in the “off” position on the remote control.
• Flip the remote control power switch to the “on” position.
• Start engine at idle speed and allow for sufficient time for oil to circulate before proceeding.
• Test all controls for proper operation.
• Avoid transversing slopes.
DO NOT OPERATE AROUND WATER, GAS, POWER OR PHONE LINES. IF IN DOUBT, CHECK BEFORE
GRINDING.
WEAR ALL PERSONAL PROTECTIVE EQUIPMENT PER ANSI, OSHA AND MANUALS.
KEEP CLEAR OF CUTTING WHEEL, MOVING MACHINE PARTS AND GRINDER DEBRIS FIELD
MACHINE OPERATION
DANGER
DANGER
DANGER
Position machine at stump with cutter wheel a slight
distance away from stump.
Reduce engine RPM to idle.
Remove the upper frame lock pin.
Raise cutter wheel clear of stump.
Engage the cutter wheel.
Increase engine RPM to full.
Test controls for proper operation, speed, and
unobstructed movement.
Cutter wheel swing speed should be adjusted to a
rate that will allow cutter wheel to pass through stump
smoothly. If jerking, bouncing or significant drops in
engine speed occur, swing rate is too rapid and must
be decreased.
Swing speed should be determined and adjusted with
the controls in the full open position.
A swing speed control is located on the remote control
to adjust this speed. Turning the dial counterclockwise
will slow the swing action. Turning the dial clockwise
will increase swing action.
Lower spinning cutter wheel to stump and make a
few light passes at stump to get a feel for the cutting
action.
Gradually increase cutting action and work away at
stump by swinging cutter wheel left-to-right-to-left
through stump in a sideways motion. Smooth,
effortless cutting lengthens machine life, minimizes
down time and is more profitable in the long run.
Continue cutting stump by adjusting cutting wheel
progressively lower until stump is cut well below
ground level.
Swing cutter wheel clear of stump and position
machine closer to stump for next series of passes and
continue cutting.
Continue in this manner until stump has been
removed.
Larger stumps may require repositioning machine to
remove complete stump.
Raise cutter wheel clear of stump and return to center
position.
Reduce engine speed to idle and disengage cutter
wheel. DO NOT TURN OFF MOTOR . Engine should
be allowed to cool slowly at idle for - minutes to
avoid damage.